Jump to content
Search In
  • More options...
Find results that contain...
Find results in...

Gpu not detected after restart

So i have this problem when i restart my pc and after startting again it Will use the igpu To run everything and it does not even detect the gtx 970 unless i take the gpu out of its slot and re slot it and turn on the pc after that then it shows the gpu and it works properly only 

Link to post
Share on other sites
27 minutes ago, Twist3relelelele said:

So i have this problem when i restart my pc and after startting again it Will use the igpu To run everything and it does not even detect the gtx 970 unless i take the gpu out of its slot and re slot it and turn on the pc after that then it shows the gpu and it works properly only 

Yea, what Finn said and if that's not it, use DDU to wipe your old GPU driver and install it fresh again. Also make sure to disable the on-board graphics first this time. The driver for it was likely installed when it shouldn't have been. Common mistake. 

https://windowsreport.com/display-driver-uninstaller-windows-10/

Link to post
Share on other sites
10 minutes ago, FinnJim3 said:

are your monitors plugged into the GTX 970 or the iGPU?

My monitor is plugged into the 970 unless it gives no signal then i plug it into the motherboard To see what is wrong and the gtx 970 does not show up anywhere

Link to post
Share on other sites
1 minute ago, stateofpsychosis said:

Yea, what Finn said and if that's not it, use DDU to wipe your old GPU driver and install it fresh again. Also make sure to disable the on-board graphics first this time. The driver for it was likely installed when it shouldn't have been. Common mistake. 

https://windowsreport.com/display-driver-uninstaller-windows-10/

Like the gpu works im running 3dmark right now but it sometimes wont show after a restart but i Will try this and i Will let you know if it worked

Link to post
Share on other sites
1 minute ago, Twist3relelelele said:

Like the gpu works im running 3dmark right now but it sometimes wont show after a restart but i Will try this and i Will let you know if it worked

Cool, DDU wipes everything back to defaults so this is like a general step like clearing your CMOS is for motherboard/CPU issues. It should fix things either way unless you have a more serious hardware problem.

Link to post
Share on other sites
37 minutes ago, FinnJim3 said:

make sure that iGPU multi monitor is disabled and then set your primary video output to pcie.

 

Also keep in mind @Twist3relelelele may have that setting on Auto (as it is usual on Auto by default) in the BIOS.

If no GPU is detected, then it would re-route to the iGPU.

 

Intel Z390 Rig ( *NEW* Primary )

Intel X99 Rig (Officially Decommissioned, Dead CPU returned to Intel)

  • i7-8086K @ 5.1 GHz (still tweaking) -- i7-6800K
  • Gigabyte Z390 Aorus Master -- ASUS X99 Deluxe
  • Sapphire NITRO+ RX 5700 XT Special Edition -- 2x Sapphire NITRO R9-Fury in Crossfire
  • 32GB G.Skill TridentZ DDR4-3000 CL14 (16GB TridentZ RGB + 16GB Red/Black TridentZ)
  • SanDisk 480 GB SSD + 1TB Samsung 860 EVO + 1TB Intel 660p NVMe
  • EVGA SuperNOVA 850W P2 + Red/White CableMod Cables
  • Phanteks Enthoo Luxe Tempered Glass Edition
  • Ekwb Custom loop
  • Logitech G502 Proteus Spectrum + Corsair K70 (Red LED, anodized black, Cheery MX Browns)

Intel Z97 Rig (Secondary)

  • Intel i5-4690K 4.8 GHz
  • ASUS ROG Maximus VII Hero Z97
  • Sapphire Vapor-X HD 7950 EVGA GTX 1070 SC Black Edition ACX 3.0
  • 20 GB (8GB X 2 + 4GB X 1) Corsair Vengeance DDR3 1600 MHz
  • Corsair A50 air cooler  NZXT X61
  • Crucial MX500 1TB SSD + SanDisk Ultra II 240GB SSD + WD Caviar Black 1TB HDD + Kingston V300 120GB SSD [non-gimped version]
  • Antec New TruePower 550W EVGA G2 650W + White CableMod cables
  • Cooler Master HAF 912 White NZXT S340 Elite w/ white LED stips

AMD 990FX Rig (Decommissioned)

  • FX-8350 @ 4.8 / 4.9 GHz (given up on the 5.0 / 5.1 GHz attempt)
  • ASUS ROG Crosshair V Formula 990FX
  • 12 GB (4 GB X 3) G.Skill RipJawsX DDR3 @ 1866 MHz
  • Sapphire Vapor-X HD 7970 + Sapphire Dual-X HD 7970 in Crossfire  Sapphire NITRO R9-Fury in Crossfire *NONE*
  • Thermaltake Frio w/ Cooler Master JetFlo's in push-pull
  • Samsung 850 EVO 500GB SSD + Kingston V300 120GB SSD + WD Caviar Black 1TB HDD
  • Corsair TX850 (ver.1)
  • Cooler Master HAF 932

 

<> Electrical Engineer , B.Eng <>

<> Electronics & Computer Engineering Technologist (Diploma + Advanced Diploma) <>

<> Electronics Engineering Technician for the Canadian Department of National Defence <>

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×