Jump to content

Couple questions regarding a rechargable arduino shield and an Arduino MEGA

werto165

https://www.adafruit.com/product/2078 

 

I've been looking into this for a project for a remote control system, I need the system to be water resistant so I was wondering how easy it is to desolder a micro usb connector from a board similar to this so that I can route the connector to where I need it in the internals of the box that will house the electronics. I was thinking of 3D printing a grommet and then spraying it with I addition I want to replace the power switch button to something more substantial like this: https://docs-emea.rs-online.com/webdocs/1587/0900766b81587626.pdf 

CPU: Intel 3570 GPUs: Nvidia GTX 660Ti Case: Fractal design Define R4  Storage: 1TB WD Caviar Black & 240GB Hyper X 3k SSD Sound: Custom One Pros Keyboard: Ducky Shine 4 Mouse: Logitech G500

 

Link to comment
Share on other sites

Link to post
Share on other sites

Micro usb port shouldn't be too hard if you have a hot air rework station. It may be better to use one of their powerboost modules to handle charging and power output.

ASU

Link to comment
Share on other sites

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×