SWIFTECH H240-X How to change for Custom Tubez

[Jimmy5Burgers]

Hello my Fellow Geeks and Nerds " does any use that saying anymore ?"

 

I have an awesome Swiftech H240-X and i would like to know if you can change the loops ? I have had a look around but no joy ! could someone with more knowledge than the likes of I be of help please !

 

Thanks

 

Jimmy  

[W-L]

6 hours ago, Jimmy5Burgers said:

Hello my Fellow Geeks and Nerds " does any use that saying anymore ?"

I have an awesome Swiftech H240-X and i would like to know if you can change the loops ? I have had a look around but no joy ! could someone with more knowledge than the likes of I be of help please !

Thanks

Jimmy  

Welcome to the Forums!

 

For the tubing they use a 3/8ID 5/8"OD tube so you will want to source the same dimension of tube. They are held in place with tubing clamps which unbolt allowing you to remove the tubing, I would recommend draining the fluid partially or as much as possible first before doing this to not make a mess.

[Guest]

Be careful my friend, Its a slippery slope, I started with that mod on my h240x, then a new cpu block, then another rad, lol 700 bucks later the h240x isn't even installed anymore

[Jimmy5Burgers]

On 22/04/2016 at 9:11 PM, Guest said:

Be careful my friend, Its a slippery slope, I started with that mod on my h240x, then a new cpu block, then another rad, lol 700 bucks later the h240x isn't even installed anymore

hahahah yeah... i'll give it ago ! thanks for the heads up tho !

[Jimmy5Burgers]

On 22/04/2016 at 7:21 PM, W-L said:

Welcome to the Forums!

 

For the tubing they use a 3/8ID 5/8"OD tube so you will want to source the same dimension of tube. They are held in place with tubing clamps which unbolt allowing you to remove the tubing, I would recommend draining the fluid partially or as much as possible first before doing this to not make a mess.

Thanks for the help and sorry for the delay ! i put this on hold till now