Jump to content

How should i get my IO cover of the in the cut out

niceFredde
Go to solution Solved by Ottoman420,

the holes almost aglined. stick that screw in and show it whos boss it will thread.

Can’t get my motherboard Asus prime Z790-A IO in the lian li O11 dynamic evo cut out for the io shield. This makes it so that i can’t screw the motherboard in the case. Is there any way to do it?

IMG_1364.jpeg

Link to comment
Share on other sites

Link to post
Share on other sites

built in io shields were a mistake
the alignment looks close enough that you should be able to, well, force it.
start with the screws furthest from the io shield, put one in, and then loosen it one half turn, do this with as many screws as you can working your way towards the io shield till you have them all in and then tighten everything up

Link to comment
Share on other sites

Link to post
Share on other sites

Even with a separate IO shield you have to press the motherboard towards the rear of the case typically to get the screw holes to line up.  It should not be an extreme amount of pressure, but some gentle pressure is normal.

Link to comment
Share on other sites

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×