Jump to content

AP Initialization after microcode loading - after enabling xmp

commanderZiltoid
 Share
Posted

Just put a new build together. MSI Meg x570 unify, 5900x, G.SKILL TridentZ RGB Series 32GB (2 x 16GB) 288-Pin DDR4 SDRAM DDR4 4000, rtx 3070. Factory bios everything boots and runs fine. I went into the bios today and noticed that my memory speed was running at the default 2133mhz. I enabled one of the default xmp profiles to run it at 4000mhz, rebooted, and now I receive error message "AP Initialization after microcode loading" 0_0. Anyone have any insight into why I may be receiving this message?

Link to comment
Share on other sites
Link to post
Share on other sites
Posted
  • Author

Just found the following thread where apparently this is a common issue with msi motherboards. When I did the bios update I used the latest stable release and not the beta release (because beta), but some users stated using the beta bios corrected this issue. Going to give that a go and see how it turns out.

Link to comment
Share on other sites
Link to post
Share on other sites
Posted
  • Author

Updating to the latest (beta) bios resolved this issue. I was able to enable xmp profile, and ram is now running at 4000mhz...nicccce.

Link to comment
Share on other sites
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing CPUs, Motherboards, and Memory

×