Jump to content

Uphere rgb hub pinout for Argb strip.

Youngin PC
By Youngin PC
in Cases and Mods
 Share
Posted

Hello I’ve been working on this for a few minutes and discovered with the cheap Uphere fans with the rgb controller that it doesn’t have any rgb strip connectors. Just wanted to show people if they have this hub that’s it’s possible to add the rgb strip connector.  The pin outs are 5v, ground and IN, NC does nothing I measured it with a multimeter. I soldered wires to the blank solder pads so I could solder the female rgb strip connector on to those red wires. I believe you could steal the rgb from the fan connectors but that’s kind of a cluster f in my opinion.

 

image.jpg

image.jpg

image.jpg

Link to comment
Share on other sites
Link to post
Share on other sites
Posted

-> Moved to Cases and Mods

^^^^ That's my post ^^^^
<-- This is me --- That's your scrollbar -->
vvvv Who's there? vvvv

Link to comment
Share on other sites
Link to post
Share on other sites
Posted

I was about to do the same thing to my own. It seems to be the newer(?) remote controlled one, and seems like it has 2 spots for generic 5v already.

 

Thanks for being brave enough to try this before me.

 

20201208_114725.thumb.jpg.0482f0448c8012d647b7e2486ca216ce.jpg

Link to comment
Share on other sites
Link to post
Share on other sites
  • 2 years later...
Posted

I lost the remote to this hub and read somewhere that there was an older hub that had a button to manually cycle the lighting modes. My question is can I jump a certain spot on this pcb to cycle the colors? If so i would like to add a button to the pcb.

Link to comment
Share on other sites
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing Cases and Mods

×