I’m getting three errors that I need help with

[aaron949]

I’m working on my computer, first build, and I’m getting a hardware malfunction, one beep followed by four beeps, a 0d and 02 code error, a cpu fan error and the wrong ram speed showing up, it says 2133 MHz when I bought 3600 MHz 

 

Asus X570-E Gaming mobo 

AMD Ryzen 9 3900X

Corsair Dominator Platinum RGB 3600 4x8GB

Samsung 970 Evo 2TB

Old Asus GPU with DVI port on it

 

[Eigenvektor]

Manual

Quote

One continuous beep followed by four short beeps: Hardware component failure

Q-Codes:

Quote

02: AP initialization before microcode loading

0d: Reserved for future AMI SEC error codes

All of this indicates some kind of hardware malfunction. If you also see a CPU fan error, then that would be the first thing to check. Is the fan not spinning or maybe not connected to the correct header on the motherboard?

 

RAM speed of 3600 MHz is an overclock, so you need to enable XMP in BIOS.

[aaron949]

11 minutes ago, Eigenvektor said:

Manual

Q-Codes:

All of this indicates some kind of hardware malfunction. If you also see a CPU fan error, then that would be the first thing to check. Is the fan not spinning or maybe not connected to the correct header on the motherboard?

 

RAM speed of 3600 MHz is an overclock, so you need to enable XMP in BIOS.

The fan is spinning, but maybe it might be in the wrong header, also I’m going to get a 2070 Super sometime soon for my computer 

[Maximusfoximus]

Check to make sure your fan is plugged into “cpu fan” rather then any other header. If your system detects no cpu fan, it may often not boot.