Can you 3D Print a dummy cpu?

[i respawn.]

Hi, as you can see my 6700K has a corner broken off. It is now completely separated. Is it possible to 3D Print the broken part (dummy obviously), glue it and use the cpu as a show-piece? Doing this for a school project.

[WereCatf]

21 minutes ago, i respawn. said:

Is it possible to 3D Print the broken part (dummy obviously), glue it and use the cpu as a show-piece?

Why would you need to 3D-print the broken part, when you have the broken part right there already and could just attempt to glue it instead?

[i respawn.]

42 minutes ago, WereCatf said:

Why would you need to 3D-print the broken part, when you have the broken part right there already and could just attempt to glue it instead?

Because it just fell off when i took the cpu out and I lost it. Why would i bother posting if I already had the broken part  

[WereCatf]

Just now, i respawn. said:

Because it just fell off when i took the cpu out and I lost it. Why would i bother posting if I already had the broken part  

I wouldn't know. You didn't mention anything about having lost it, you only showed a picture where you have it, so assuming that you have it is perfectly logical.

[UrbanFreestyle]

1 minute ago, i respawn. said:

Because it just fell off when i took the cpu out and I lost it. Why would i bother posting if I already had the broken part  

Dude that kind of attitude does not make people want to help you.

Yes you could 3d print it and glue it on, a little bit of paint and you could probably get a close colour match, Although i would suggest printing out the whole thing as printing that small could be an issue (or maybe use a SLS printer?)

 

https://www.thingiverse.com/thing:3486227

and while you're at it, it might be worth printing a case too?:

https://www.thingiverse.com/thing:2130142

[i respawn.]

1 minute ago, UrbanFreestyle said:

Dude that kind of attitude does not make people want to help you.

 

I didn't mean to sound rude. Thought it was just obvious.

[i respawn.]

4 minutes ago, UrbanFreestyle said:

 

Yes you could 3d print it and glue it on, a little bit of paint and you could probably get a close colour match, Although i would suggest printing out the whole thing as printing that small could be an issue (or maybe use a SLS printer?)

 

https://www.thingiverse.com/thing:3486227

and while you're at it, it might be worth printing a case too?:

https://www.thingiverse.com/thing:2130142

Thanks a lot.

[i respawn.]

6 minutes ago, UrbanFreestyle said:

Dude that kind of attitude does not make people want to help you.

Yes you could 3d print it and glue it on, a little bit of paint and you could probably get a close colour match, Although i would suggest printing out the whole thing as printing that small could be an issue (or maybe use a SLS printer?)

 

https://www.thingiverse.com/thing:3486227

and while you're at it, it might be worth printing a case too?:

https://www.thingiverse.com/thing:2130142

Any idea how much it would cost tho?

[UrbanFreestyle]

Ok i think a little miscommunication in the original post. 

Anyways. Have a look on Yeggi as there are other models and some display cases available too.

[UrbanFreestyle]

Just now, i respawn. said:

Any idea how much it would cost tho?

If you have a printer probably about $0.50 I ran it through my slicer and it came out dirt cheap.