Jump to content
Search In
  • More options...
Find results that contain...
Find results in...


  • Content Count

  • Joined

  • Last visited

Everything posted by DSD

  1. DSD

    Freesync quirks

    Hello all, I purchased a Gigabyte G34WQC monitor. It has freesync premium, allegedly is g-sync compatible and is 144hz. My computer is the Asus ROG strix scar ii laptop (GL504GW). It has an RTX 2070 with both mDP (1.2) and HDMI (2.0b) out from the card itself. Here's what I'm experiencing (resolution is always 3440x1440): At 60Hz, everything is fine. At 100Hz, I can run games fine now that I've upgraded to a UHS hdmi cable however if I turn the monitor off or turn freesync on or off, signal is lost entirely until I reduce back down to 60Hz.
  2. Take my recommendation with a grain of salt as I dont have lots of experience buying monitors but if you want something of (potentially) higher quality than the gigabyte but still not too expensive how about the MSI Optix MAG341CQ or the Asus TUF VG35VQ? I'd look at some reviews but specs are similar with what looks to be better build quality.
  3. I can update after troubleshooting it for most of the evening that the issue of losing signal was down to me running it at 100hz via my laptop's hdmi port which did not support it (user error). Switching it down to 60hz via hdmi fixes this. I have a mDP on order which should allow it to run at 144hz. What is the fault of the unit though is that the joystick is trash, as per my first comment, wont register and up command and wont turn off. GL to you mate. If I were doing it again, I would spend a couple hundred quid extra and save the headache.
  4. Some of this will likely be user error but nonetheless at this point I can't recommend it. Initially it had random green flickering pixels and a line across the lower half of the screen. This went away when I changed the hdmi lead (previous one worked fine on old monitor). Then the joystick control stopped registering an "up" input. Then I discovered that games caused the monitor/laptop to lose signal with freesync turned on; then when turning freesync off, I found out that doing so causes the monitor to entirely lose all signal without a hard reset. Between the above, the fact that it won't t