Jump to content
Search In
  • More options...
Find results that contain...
Find results in...

Selth Afrinon

Member
  • Content Count

    7
  • Joined

  • Last visited

Awards

This user doesn't have any awards

About Selth Afrinon

  • Title
    Newbie
  1. Sounds good. That'll go into the budget for next month. I'm just glad that it isn't a problem with defective components. Thanks for hearing me out.
  2. So with the same GPU clock speeds, Heaven 4.0 temps look like this: Lowest fan setting: 55 - 59 deg C Highest fan setting: 50 - 53 deg C So there's a good difference there. I guess I'll just run everything at stock until I can add a new radiator to the loop. Cool, I'm glad the issue isn't with the pump. I originally considered front mounting a 360 radiator, but I need the 3.5 cages in the front to act as my primary media storage. The most radiator space I think I can get into the case is 280 or 360 top, 140 back, and 120 bottom. With a few changes to layout
  3. Ok, made sure res is topped off and reran tests at stock CPU and GPU settings (GPU was at stock settings when performing the water cooling tests from original post): Stock: CPU Temp Idle: 33 - 40 deg C (4.3 GHz stock turbo, 1.296 V) CPU Temp AIDA64: 53 - 56 deg C CPU Temp Max BOINC: 60 - 63 deg C GPU Temp Heaven 4.0: 58 - 59 deg C
  4. The case is a Corsair 780T. I looked over the loop, but I didn't see any pinching. All tests were run with the side panels off at the time; I reran Aida and max BOINC with the side panels on just now and the temps remain around the same. I'm considering either adding a 140 radiator on the rear exhaust or a second D5 pump in serial (or both). Do you think these changes would make a significant difference?
  5. The D5 is set to 5 for all the tests. For the picture, the res/pump combo is on the right. Intake and output run behind the mounting plate: the bottom-left run is pump output and runs into the GPU, CPU, then top-mounted radiator, then behind the mounting plate again. I had originally planned to mount a 140 radiator on the back, but I didn't have the budget for it this month. Should i be expecting temps 3-5 deg C higher than my air cooled setup with my current water cooled setup? Do you think a single 140 would make a lot of difference? Or would I need more to g
  6. Hello everyone. I just finished putting together my first custom loop and I wanted to know if the temps I'm experiencing are what I should have expected compared to when I was air cooling (see setups at bottom of post). I when I was planning out the custom loop, I was hoping to decrease my CPU and GPU temps by some noticeable amount (5 - 10 deg C would have been nice), but instead I have a 5-10 deg C increase to CPU temps and a 10-20 deg C increase to GPU temps at the same loads. Here's what I've tried to get better temps so far: 1) Removed the old TIM and a
×