Jump to content
Search In
  • More options...
Find results that contain...
Find results in...


  • Content Count

  • Joined

  • Last visited

Everything posted by Lauen

  1. Yes, but I can't go further than 120hz. Sure, the difference between 120 and 144 isn't a whole lot in my experience but I would like to get the full experience.
  2. Not entirely certain if this is the correct place, but lately I've been noticing that if I hit Windows + P to disable output to my secondary monitor (ASUS PA238Q 60hz via DisplayPort) my primary monitor (144hz SAmsung C24FG73 via DisplayPort) will be limited to just 120hz. I get 144hz again if I turn the secondary monitor back on. I'm using a GTX970 with a mild overclock, but the issue was there before I overclocked. My other specs are on my profile if need be. Windows 10 64bit, fully updated.
  3. Those are two wildly different headphones. Sure the 598's are better, but they don't have any noise isolation because they are open headphones, unlike the M50X and all other closed sets of headphones. I think you should explore other options here to be sure you get the best headphones you can in your budget, for your use case. If you're dead set on those two you listed, get the 598's.
  4. I have a pair of M50S lying around somewhere. I only tolerated them (with daily use) for about 3-4 months or something like that. I agree with all the points you make in the OP, and I'd like to contribute a quick thing: Shure SRH440 with pads from the SRH840 (sold as Shure HPAEC840 and also fit the M50S) are a LOT better. Cheaper, more comfortable (I found M50S pads to be too small and as such rested on the edges of my ears and they got rock hard over those few months I owned them), a more balanced sound with better definition, a wider soundstage, and since M50S (old version) didn't have an ea
  5. Last update. After testing all sorts of combinations of RAM sticks and slots, I've concluded that one of the sticks of RAM was faulty. I'm currently using the PC with just 1 stick of RAM and have contacted retailer for RMA, and they are sending me a brand new kit with no requirement to return the kit with the one faulty stick. This then naturally results in me getting 3 sticks of RAM so I'll get 12 GB with only cost being my time. Very frustrating that none of the error codes I ever got were actually related to RAM.
  6. Sorry for practicing necromancy on this thread, but after RMA'ing the motherboard, the retailer sent it back claiming there were no issues at all with it. I rebuilt the rig, and had the exact same issues as before right away. Freezing all the time, random black screens, a bluescreen every once in a while. My brother who lives in the same dorm as me has an almost identical rig, and I swapped around some memory from his rig with some luck, it seemed to run fine with his memory. I tried my memory again, one stick at first, was fine, then added the other and the issues came back. Afte
  7. Gotcha. I will be speaking to the support department of the etailer I bought all the parts from.
  8. Seems I don't even need to be playing games for my PC to crash now, just bluescreened with "video scheduler internal error" while just watching a youtube video.
  9. Disconnected the DisplayPort and ran only HDMI, no difference at all, still freezes.
  10. I also just experienced, whilst trying the game RimWorld to see if that works any better than CS:GO, the game crashed, my main monitor (the Samsung C24FG73) video signal got cut, and I had to unplug and replug the DisplayPort for it to show up again. event viewer is littered with "Display driver nvlddmkm stopped responding and has successfully recovered."
  11. It's a Samsung C24FG73. I'm connected via DisplayPort and I have tried 2 different DisplayPort cables.
  12. I used DDU to remove the newest driver in safe mode, rebooted, downloaded and installed driver 385.41, started up CS:GO and 1 second after spawning, I get a BSOD with "video scheduler internal error".
  13. The other cards I have handy (as described in OP) seem to be dying, as with those the freezing happens a lot more often, and even BSOD some times. Those used to be overclocked but I reverted to factory settings, and my current setup is running completely stock too. Before I got this new card, I tried 4 different drivers, from March 2017 up until the newest one, had same error with all of them. I can try new card with old driver in just a sec.
  14. I should maybe also mention that after getting the new graphics card I did a completely clean reinstall.
  15. I did a complete format of BOTH drives and clean reinstall (multiple times). In the event log I see a BUNCH of errors with the following description: The description for Event ID 13 from source nvlddmkm cannot be found. Either the component that raises this event is not installed on your local computer or the installation is corrupted. You can install or repair the component on the local computer. If the event originated on another computer, the display information had to be saved with the event. The following information was included with the event: \D
  16. oh and I'm using Windows 10, should be fully updated as there are no updates when I search.
  17. Been having this issue for some days now. Recently built a brand spanking new system apart from case and SSD's. I pretty much only play Counter-Strike: Global Offensive but the game will freeze randomly, and sometimes the entire system just stops completely, and sometimes it just restarts. I have reinstalled Windows several times, tried both of my SSD's, tried 3 different graphics cards, but the problem persists in one form or another. I had a similar issue right before christmas, but that was on a different motherboard, cpu, ram, graphics card, and power supply. Temps are A-Okay
  18. G903 has the same sensor as the G403, G703, and maybe even G303 and G302, and G Pro so it has the same tracking. Practically all of Logitech's G series mice have "perfect" tracking nowadays, and it's becoming increasingly common that mice have close to perfect tracking. G903 also has what is supposedly the best wireless system, and wireless charging as well.
  19. The G403 is already one of the best tracking mice, so in terms of tracking accuracy, and there being no acceleration and deceleration, there won't be much of a difference.
  20. How come almost nobody has noticed the fact that the X2 card's PCI-e interface is too far away from the bracket? lul, very obviously fake. And why would an X2 card have the same SP's as a single?
  21. You must be thinking of the video about DPI and CPI. (this one) PPI has literally nothing to do with mouse sensitivity. It's just how many pixels there are per inch on a screen.
  22. Only thing I can really think of at all is mouse acceleration / deceleration in the games you play other than CS:GO. Just make sure the "enhance pointer precision" is unchecked. Also judging by the specs in your profile you are definitely getting >60fps in games so input lag shouldn't be a thing. I'd say the games just have bad mouse support. Changing mouse shouldn't help in theory as CS:GO works just fine.
  23. You have to be specific. I don't know what games you own.
  24. cool. What games specifically does it happen in?
  25. Do you have Vsync enabled in the games the mouse is weird in? Cus considering CS:GO is fine, your mouse should be fine. Vsync, if badly implemented can give you massive input lag. Sometimes in even worse games it's the other way around and you need to turn ON vsync. Try it out.