3d printing Flashforge Dreamer 3D Printer Taking Several Minutes to Boot Up.

INTEL_HP_2002 · April 16, 2018

When I turn on my Flashforge dreamer it gets stuck on the boot screen for several minutes as shown in the attached picture before booting up fully. I've tried booting with and without an SD card. I have not updated the firmware on the printer and have not had the issue previously. Does anybody have any ideas about what is wrong/how I can fix this?

Thanks

Hackentosher · April 16, 2018

Sounds like a firmware issue to me. Try reflashing.

INTEL_HP_2002 · April 24, 2018

sorry for the delay but I've tried reflashing the firmware through flashprint a couple of times and it still takes ages to boot

Hackentosher · April 25, 2018

4 hours ago, INTEL_HP_2002 said:

sorry for the delay but I've tried reflashing the firmware through flashprint a couple of times and it still takes ages to boot

Contact flash forge then.