Newly built pc wont show any video output

[Lataupe]

I am new to building one and this is my first one. The components are the following:

CPU: Ryzen 3 1200 with the stock cooler
MoBo: MSI B350 Tomahawk
Ram: Corsair Vengeance LPX ddr4 8gb (2x4gb) 3000Mhz CMK8GX4M2B3000C15R
GPU: EVGA 1050ti 4gb SSC
HDD: 3.5" Seagate Constellation 2TB 72000rpm SATA 6.0gb/s
PSU: EVGA 450w 80+ bronze BT
Case: Corsair Carbide Spec Alpha

Monitor: e-machine 18.5" 

 

No idea what bios version is
i have already checked the wirings and everythings seems to be in the right path and nothing was left out. Also tried plugging in with the hdmi port in the motherboard instead of plugging in the GPU nothing happened at both tries, resetting bios by removing the battery in the motherboard.

[LHJKO]

are there any debug leds on 

[BubblyCharizard]

does it work if you plug the GPU into another  PCIe slot?

[PeachyUwUSenpai]

did you plug in the cpu power plug and not just the big motherboard one

[Tosa]

Does it power on at all? Does the fans start spinning? 

[Lataupe]

The system powers on. And cpu power plug is in its place. Already tried in a different PCIe slot same result

[Lataupe]

8 hours ago, Vernw3 said:

are there any debug leds on 

Yea CPU and DRAM

[LHJKO]

40 minutes ago, Lataupe said:

Yea CPU and DRAM

ok thens its the ram i had the same problem it needs to be in the slot closet to the 24 pin power t(the bih power connector you plug into the motherboard)or the slot 3 over from it 

[Lataupe]

17 minutes ago, Vernw3 said:

ok thens its the ram i had the same problem it needs to be in the slot closet to the 24 pin power t(the bih power connector you plug into the motherboard)or the slot 3 over from it 

Its already on that slot and still same thing. Aldo tried moving it

[LHJKO]

Just now, Lataupe said:

Its already on that slot and still same thing. Aldo tried moving it

try booting it with only one in the first slot 

[Lataupe]

Always same ending. "No signal" status on monitor when i turn on the power on the system. Also this time its just CPU led light on the EZ Debug LED

[PeachyUwUSenpai]

3 hours ago, Lataupe said:

Always same ending. "No signal" status on monitor when i turn on the power on the system. Also this time its just CPU led light on the EZ Debug LED

try running the computer with only one ram stick and try doing it with both sticks separately 

[Lataupe]

2 hours ago, Alaradia said:

try running the computer with only one ram stick and try doing it with both sticks separately 

Already did that. In all ram slot

[Lataupe]

Is it possible that my CPU is dead????