-
Posts
57 -
Joined
-
Last visited
Artsi23's Achievements
-
Yes of course those are all DDR3
-
Okay I think I should buy that 8GB kit and either ditch the team elite one or try them together seen how it deals
-
I'm doing an upgrade and I had a two sticks of 4GB Team Elite 1333MHz and one of them died few years ago. I found two possible option in upgrading theres Kingston Hyperx Blu 8GB (2x4) 1600Mhz and Kingston Hyperx blu 4GB (2x2) 1333MHz . I'm wondering if the 1333Mhz ones would be compatible with my Team Elite stick or should I just buy those 1600Mhz? These are DDR3 and I found those used. Thanks in advance
-
Oh I'd like to have a usb charger because I was thinking of adding really good batteries, so I could charge a phone while using the boombox
- 16 replies
-
Do either of you have any suggestions or advices for my plans?
- 16 replies
-
Anyone know is it possible to rewire those buttons with different ones? so I could have them attached to the case
- 16 replies
-
we have few old stereo system speakers in the garage, two pairs of different kinds. Both were 4 ohms and other 20W and others powerhandling marked 25/35W. Those have crossover woofer and tweeter. only promblem is that they might be too big for this case. Might be a tight fit so I'm not sure if its a good idea. It'd be cheap tho.
- 16 replies
-
Okay I'm going to also add this USB charging port so you can charge your phone and I need to figure out somekind of charging system so the battery wont overcharge
- 16 replies
-
Okay so I decided to use this amp since its poweful and can power with only 12V
- 16 replies
-
so yeah I should probably connect them with a crossover, any suggestions for boards I should get for that?
- 16 replies
-
Oh yeah then that amp Brenna_Prince suggested would be good, I have looked at it before. but the only thing is that I'm not sure how to wire up like two mids and tweeters to that
- 16 replies
-
I would love to get feedback and advices on how to build it because I'm not an electrician or amazing with electronics. Help is much appriciated
- 16 replies
-
I was thinking of building a ghettoblaster/boombox bluetooth speaker into this old briefcase/case. I was thinking of a 2.1 build using an amp something like this http://www.ebay.com/itm/Douk-Audio-HiFi-TPA3116-Bluetooth-4-0-Digital-Amplifier-2-1-Subwoofer-amp-Board-/272023476134?hash=item3f55dcd7a6:g:IlQAAOSwA4dWKFp1 and I could maybe fit two 5" drivers and one 8" or something along those lines. Also adding a way to charge a phone from it would be nice. So suggestions for wiring, drivers ,amps etc. Here are few pics of the briefcase and some kind of wiring plan I made(very bad one). Ps. Also suggestions for good places to buy drivers and other supplies in Europe maybe from Germany to ship to Finland
- 16 replies
-
Earlier I wrote a topic of modding a bluetooth speaker but my plans changed a lot. I was thinking of building a small bluetooth boombox into a small vintage suitcase (size about 41x27x14cm) and scrapping an old speaker (pics below) and maybe old speaker set(havent found it yet) for drivers. So idea was to use an amp with bluetooth something like this and adding a big battey to power it all. I'm hoping comments if this is a good idea and suggestions what I should change. Also better suggestions for the amp! Some pics below of the old speaker in a garage.