AdzOnTheMic

As in if I was to disconnect the drive from the pc? In that case bios opens and well there’s not much to do from there

Yes that’s the one I select

The boot priority has already been set on Windows Boot Manager (M.2_1:Samsung SSD 970 EVO Plus 1TB).

I have built a new PC with all the same components except from my motherboard because it died. I am using my NVME and SSD from my previous build so it has windows already installed on it. BIOS also reads both SSDs, however I also get a A2 error code (motherboard is Asus xii formula). I am able to boot override and windows runs perfectly. How can I fix this?

I’ll see how this goes, if the problem isn’t solved then I will go ahead and clean out the system.

I feel that this is fungus of something along those lines, I’ve added a few drops of biocide and I am allowing the system to run. Hopefully thatll solve the issue.

The particles are swaying a lot and quick speeds, especially when I up the RPM. I do think there is moving water present. Perhaps this is due to bad quality water or not enough chemicals?

Looks like a stringy cluster of loose particles which sway in the direction the water flow is.

I built this pc about a month ago and I used distilled water, washed my radiator out, added a few chemicals to prevent corrosion and algae etc and suddenly (a month later) I see these odd stringy fluff like things in the pump and CPU block. what is it? What do I do and how do I prevent it? I thought maybe I didn’t turn my system on for a day or two and it was caused due to stationary water.

Would I need a three way splitter or just a two way?

Oh sorry, when I plug my headset into line out the audio works, doesn’t work when I’m line in

I recently build a new pc and I can’t seem to figure out how to be able to use my headsets mic. The motherboard I’m using is the Asus Maximus Formula XII. When I plug the headset into the line in I can hear the audio yet my mic doesn’t work, when I connect my headset to mic in and line out I don’t get any audio. Is this a windows error? If so what do I do

Whenever I try measuring a bend in a loop or the general length of a tube I’m always off. Any tips or things to make it easier?

It was a black background, the camera just picked it up as blue. Would you recommend trying out another panel?

I bought a new monitor for around £650 and I noticed the backlight bleed. What should I do?