M4R1S

Your setup is gold ahaha ;D

Update: New Riser Cable, everything working perfectly! Thanks for the help, it really helps finding problems

80°C at absolute max. Custom case

I've run the benchmark again, didn't crash. Earlier it sometimes freezed, no signal, signal again, blue screen, BSoD. I also heard the "unplug" sound that plays when I unplug my mouse... Temps up to 97°C and then jumps down to 30°C in like two seconds.

But it crashes if do anything and clocks to the absolute max

Hi guys! I have a riser cable installed and my graphics card is downclocking to 135 MHz The temps jump up and it clocks normal if I open the browser or anything... For a short time, I was able to run a benchmark where it performed slightly worse than normal. What can I try?

Hi! This is super strange. My riser cable only works in the first pci-e slot which is not surprising because the second pci-e slot only runs at x4. BUT if I connect my graphics card directly to the second slot it works just fine. My motherboard is the Aus ROG strix b-450 f Gaming. Ist there any way I can use the second pci-e slot with a riser cable? Why does it work work without it? thx

Hey Guys! So I think this will work but I just want a confirmation: I have the rog strix b450-f with two 4-pin rgb headers. I want to add rgb like freaking everywhere in my case. To my graphics card and everything. I've heard that the wiring of the rgb header is ground, r, g, b. So I just connect like 12v rgb stripes to this? They should be working with Aura Sync? Yes hehe? I may be completely wrong and if so are there other methods?

Yeah, I've already emailed them about the wrong fan. They replied and changed their shop. Now they're selling normal fans, not PWM. They probably have no idea what they are selling, pretty weird... About the soldering: I'm building a custom wall mounted pc (case) out of wood. Rearranging will be a bit harder. Besides that, I have all the tools I need except a wire stripper. In the past I've used scissors but I'm thinking about buying one because I have to solder every single cable of my psu again (I had to cut it so the hole doesn't get to big).

Second: The slower one has a 3-Pin Connector, the faster one a 4-Pin. So it will run at the same amperage (amperage?) as the faster one. Btw you can't even put two 4-pin connectors onto one fan header even with an y-cable. The pwm cable of one of them will always be disconnected

god damn it, I just told you it doesn't work. Read my comment again but slowly. You can build a switch into your keyboard that has a cable running into your pc. But that wouldn't be a keyboard anymore.

Why solder them together? Why would I spend money on y-cables?

Although your cable management isn't perfect, the temps are quite unusual. GPU's should be around 75 to 85 under load. All of the GPU fans are working?

You can't because the power supply has to be short surcuited through the motherboard to start at the first place. There's no USB device that can do that since... well... idk it just doesn't work