XIVSkippy

thanks so much! will have a test of these things

This was from a test print I just did

oh sorry, yes it is!

PLA

Hey guys, had my printer for 2 months now and am running into issues trying to print bigger parts Ive added some images basically it’s a whole bunch of issues as I can tell plastic is fraying and burning and not sticking any solutions? thanks!

thank you! i was worried id done something wrong!

sorry! Ryzen 3 1300x ill try those now! thanks

Hi guys! just got a new CPU cooler (MasterLiquid ML240L) and my cpu temps have been fluctuating like crazy, idle, it goes from 30 degrees to 40 degree, then slowly drops, is this normal?

Thank you very much! So a 50/50 rgb strip, but I’ll only be able to use a single colour, I presume red

Hey guys, a bit of a strange question, my motherboard has a JLED pin on it, but nowhere on MSI website does it say that it comes with one, and it’s all very strange motherboard : A320M pro vh I haven’t tried connecting anything to it over fear, any ideas? thank you

yes, but this is an issue thats only started in about the past week maybe? i did mess around with priority setting not sure if that wouldve caused it?

hi guys! been noticing my pc is running quite slow recently? ive tried trouble shooting (cleaning my hdd, reset cmos, update drivers (gpu and cpu)) but cant seem to speed it up, launching an application takes ages but read/write doesnt seem to be that bad? ryzen 3 1300x rx 570 8gb armor 8gb ddr4 ram 1 tb barracuda hdd any ideas would be much appreciated ! thanks

it really depends on how lucky you are, you getting shocked could have drained the charge, or passed it on to the motherboard. how many components are in the pc as of right now

why? is it a sensor issue?

Hi guys! im having a problem with my mouse (Logitech g402) where if i move it too fast, to do a flick or a fast 90, it almost ghosts me, as in, it will stop moving on screen???? like in this clip, i got to turn my mouse fast to do a 90 and it ghosts me 2019-12-13 19-54-56_Trim.mp4