Jump to content

Skyhighedition

Member
 View Profile  See their activity

  • Posts

    10

  • Joined

  • Last visited

Awards

This user doesn't have any awards

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Skyhighedition's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Skyhighedition
    Do u think I have to remove the air bubble from the cpu block or do u think it will come out on its own and is it ok to run the pc when it’s in there
  2. Skyhighedition
    The block dose have a in and out lable the in fitting is connected to the rad and the out fitting is connected to the res
  3. Skyhighedition
    I have gotten most of the fluid thru the system. But there is a air bubble in the cpu block. I’m trying to get out. I’m not fully sure if I have the water flow going in the right direction cause the bubbles are resisting. also if I start my pc and there isn’t enough flow would it burn up my cpu ?
  4. Skyhighedition
    I am moving it around some and I tiled the case back and a lot of bubbles came into the res the the bottom tub filled up alittl
  5. Skyhighedition
    Here is a pic of the molex connector its selved well but the right back( the one my finger is on is the red cable
  6. Skyhighedition
    I will try laying it on it’s back. Just the pump does not want to move the liquid.
  7. Skyhighedition
    I will try that, the pump is the ek revo d5 red/pump combo. Do I have my loop set up wrong ? There is a in and a out on the pump/res the In is going into the cpu and the out is going to the rad. Then I have the left tube connected to the cup and the other end into the rad
  8. Skyhighedition
    I have been trying to tilt it and cycle the pump about 20 times now still no luck sadly. I took the left tube off the rad and tried to see if I could get a flow going and still no luck but now the res level of liquid moves down when I turn on the pump
  9. Skyhighedition
    I have tried to cycle the pump 15 ish times. Now still continuing to do so but I don’t think it will work. Every time I turn it on it sucks in some of the liquid from the tube. Then when I turn it off it spits it back out. But never takes any from the res. Do I need to have my cpu pwr 8 pin plugged in to have to run? 59277266713__4DD42344-AD49-4E93-984C-1E8647A7D5FC.MOV
  10. Skyhighedition
    Hi y’all, my ek revo 5 pump is sadly not pumping my ek liquid I got. I have the 4 pin female connected to the cpu fan header. Then the molex connected to a molex connecter from my psu and it’s connected into my psu through a 4 pin cable. When I started the psu the pump spins up and turns on. It had taken it about one full reservoir full of liquid. Then I turned it off and poured more in then turned it back on and the water goes back down the tube to the pump then dosnt move. And the liquid in the res is just chilling not moving at all even tho the pump is on
×