Jump to content

Houstonruss

Member
 View Profile  See their activity

  • Posts

    6

  • Joined

  • Last visited

Awards

This user doesn't have any awards

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Houstonruss's Achievements

Newbie

Newbie (1/14)

1

Reputation

  1. Houstonruss
    Just did some maintenance on my rig...(cleaning the loop) and added some cable combs. I also put some addressable LEDs in the monoblock! Some crusty tubing before: nsf pcmr Last year: https://imgur.com/a/BH5C2jf Current: https://imgur.com/a/ofieKZW Whole setup: (old pic)
  2. Houstonruss
    Temps are a bit better now. Not sure if it's the cleaning the paste or the remounting. Bleeding it now...
  3. Houstonruss
    New LEDs look nice
  4. Houstonruss
    Yeah its EK Ectotherm, I don't know if the pump out effect is the issue, the mounting, or just the fusion reactor of an i9 being hot regardless. 40c idle 100c+ full load. Won't be able to get it running tonight so I guess I'll have to finish up later. Did an led mod to the water block after cleaning it. It was pretty clean inside.
  5. Houstonruss
    Yeah I had the pads and washers right. I'm guessing it was just not tight enough. I'll have to bench test it in a few hours and see If the thermals get any better.
  6. Houstonruss
    Doing some cleaning on my rig and this is the spread pattern from the thermal paste over a year... I want to know if the spread pattern is indicating if I'm not mounting the monoblock tight enough or if this is normal. Not delided or anything.
×