Jump to content
Search In
  • More options...
Find results that contain...
Find results in...

Lipe123

Member
  • Content Count

    290
  • Joined

  • Last visited

Awards


This user doesn't have any awards

About Lipe123

  • Title
    Member

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. uh dude, does you pc still turn on.. then its not fried. Also modern cpus can be run without any heatsink for a short bit with no issue. Double check that you are providing power to the aio properly, find the install manual for it and follow the steps.
  2. No current flows toward the direction of least resistance. You basically have a galvanic battery with a + and - side and now you are putting a wire between them and then also connecting that wire to ground. The shortest route for current would be directly between the components not to ground in this case. Cathodic protection is stupid, that dissolving metal is going to cause buildup of small particles and its a short term fix. Bro you are trying to make this work too hard. If it was a thing everyone would be doing it.
  3. Rotate it 90 degrees so the tubes come out the top or bottom?! They don't have to come out by the ram or am I missing something here?
  4. Check out dazmode, other than amazon is the only canadian reseller I know of. https://www.dazmode.com/shop/watercooling/ek-classic-kit-s360-d-rgb/
  5. Literally using the word "ground" means current flow to ground. And you are connecting all the components together , the path to the other components will then have WAY less resistance than a ground connection. Ground is literally a stake in the soil outside your house, it's not exactly and amazing conductor.. so you will promote current flow between the components. When there is current there is corrosion.
  6. I'm in Canada so I got these from Dazmode: https://bitspower-warranty.com/index.php?route=product/product&product_id=411
  7. A new o-ring might help especially if it's an older fitting. I bought a 50 pack of o-rings recently for super cheap and every time i change fittings I change their o-rings also.
  8. The wire just makes everything worse by allowing even more current to pass between the metals. Use a chemical corrosion blocker.
  9. Bro, you asked... don't complain about the answers
  10. You keep mentioning distilled water, did you add anything to prevent algae growth? If you run ONLY water with nothing else you will get algae over time from contamination etc.
  11. check the FAQ's . This is like asking if you should mod a car to have 8 wheels instead of 4 ridiculous... You can totally do it if you want to waste a bunch of money but its WAY overkill and also the order of the components makes no difference.
  12. There is very little flow restriction with a normal rad, you need to all the volume of all the channels up to get the total flow capacity and it should be much more than the cpu/gpu block restriction. Front intake or rear rad is going to be more or less the same, the air will be warm by the time it gets to the rear soo meh? Even though air passed through the front rad it might not be fully saturated and still be able to collect heat on the way out. Or just reverse the flow and make the front an outlet and the rear intake.
  13. Crossflow rad's should be MUCH more popular! I have one and it just makes so much more sense.
  14. Stock, literally just opening a new tab in a browser makes it instantly spike 10 degrees and then a second later it drops back down. I think there is a huge range of quality control with these chips
  15. My 3600 with a custom loop spikes into the 70's I think these chips are just terrible at transferring the heat to the top of the cpu. The temps spike wildly in less than a second, to me that means there is just not enough conductivity between the top of the cpu and the insides.
×