Balto16

this is the kind of answer i was looking for, thanks!!!

no, i tried before but they say ists only for internal uses.

Hi, I was trying to make some changes in my home network and end up having troubles with this modem/router, the thing is that these modems use a password of the day system and my internet service provider set up a different seed soo I can't use any generator, in my mind is a good idea to perform a factory reset for being able to enter the config. The main doubt is if this factory reset could cause any impact on my network in terms of not connecting due to setting missing, I should proceed?. the model of the modem is Arris TG1672G

The problem is the next 1 gaming PC 1 Tv they are too far from each but in the same house I want to play on my tv without moving the pc from where it is my internet connection isn´t too good for using cloud streaming and barely enough for Lan streaming, also due to the quarantine I can´t buy stuff I tried to install retropie with parsec, which was not so good due to commands and problems installing packages. but that does not matter since using parsec between 2 PC's with Windows 10 shows that the quality was not good. Then, I tried steam link and moonlight + Nvidia experience stream to take full advantage of the Lan connection capacity, the results were decent but with quality problems due to the low bit rate due to my internet connection. I remembered that I had an l300 NComputing, perfect because it did not need much connection, it worked for Lan, I could create a user to protect my information and many advantages. the problem is that I create these devices and for the most part the virtual machines do not share the video card, so there would be no joke. my question is: Do these drives share GPUs or could they? Any idea to be able to play on my tv without dying trying?

is not overheating, the thermal paste was replaced today. thanks for the answer

recently i take out my old gtx titan (original) and placed in a build, unfortunately the graphic during high loads crash and just stop sending signal. i used msi afterburner to limit the power consuption to 80% and 70c as max temps the temps in standby runs at 46C that is ok the graphic card crash couple of seconds after start 3dmark the specs are I7 2600 16gb ram the gtx titan 600W PSU my next idea is to limit more the power consumption to see if there is any problem with that (i dont think) or to reflash the bios of the gpu. any idea?

Il try, thanks

Hi guy, me again Thanks for replying really fast to me problem but i have to tell you that the problem is present during the bios, meaning that is something physical or just not about drivers

Hello, my gtx titan after some issues with the energetic source of my country suffer a lot until the point of showing blue lines around the screen and now multicolored spots. I isolate the variables and really sure that the gtx titan is damaged. If someone can help me, i will be glad.