BU MA
-
Posts
27 -
Joined
-
Last visited
Reputation Activity
-
BU MA reacted to rice guru in Sound Blaster Audigy RX 7.1 How do I configure this software?
24 bit @44.1khz should be more than fine
-
BU MA reacted to Jurrunio in Just Overclocked my i5 7600K, how does it look?
set the base clock (BCLK) back to 100MHz, then use 48 as multiplier.
I'd suggest using manual voltage first, setting loadline calibration (LLC) to level 3 or medium, then use stress test (I use Prime95 small FFT) to find out the minimal stable voltage (Start at 1.35v). Then get back into the BIOS, reduce loadline calibration to the lowest level (the higher the number, the lower the effect of LLC), then turn the voltage mode from manual to Adaptive mode, then enter a voltage that's 0.02V higher than the minimal stable voltage you tested out.
-
BU MA reacted to For Science! in CPU Fan/Chassis fans RPM during stress test.
yes. the h100iv2 reports back the pump rpm, not the fan rpm. the Pumpoperates best when receiving a constant 12 V across all temperatures. provided you have fans plugged into the headers coming off the pump block, then tou have a correctly set up H100iv2.
-
-
-
BU MA reacted to sh4z in Just Overclocked my i5 7600K, how does it look?
4.6329? The 9 means its extra fast
-
BU MA reacted to Enderman in Just Overclocked my i5 7600K, how does it look?
What do you get when you divide 4632.9 by 1000?
-
BU MA reacted to Electronics Wizardy in Motherboard running VERY HIGH temp
no pins that you can use, but the chip on the board that reads temps normally has support for something like 6 sensors. There often not all used, and just show a bogus result if nothing is connected.
-
BU MA reacted to Jurrunio in Benq XL2411
If you want colors, look for VA panel-equipped monitors like the Samsung CFG70. Other high refresh rate monitors all use TN panels which inherently dont give very good colors.
-
BU MA reacted to Glenwing in Benq XL2411
That is a baseline feature, all monitors have that including the XL2411.
The difference is that the XL2411P has DisplayPort input, which is important for computers that don't have a DVI output. That's all.