mrcrunchy

Alright that's what I thought, the ab350 board is only two pins.

I have a real simple question. Can I add a cmos button, like the reset button from a computer case to the cmos jumpers? You know so I don't have to do the screw driver method. Not saying it's going to be the reset button, but a button put on the back of the case. I like the way my Asus x370 has it.

I figured on either isolating it in electrical tape or something so it doesn't short to case. Does have enough clearance I tried that.

Okay gigabyte gave a 4 pin and a 5 pin on the board but put the 4 pin pretty much the middle of the board and I don't want to run the plug there. Can I not use the 5th white led pin and plug in a 4 pin rgb connector? I couldn't decide if this would go here, peripherals or motherboards. So I put it here.

ekwb makes some, they sell them with prefilled graphics card blocks. https://www.ekwb.com/shop/ek-qdc-10mm-gray

heh i remember them. are they still around?

The price is literally on fire!

It's a big $44ish on Amazon. Sure beats an evga g2 gold. Also my phone just auto correct evga to vega...... Just thought it was funny.

Must have one of those special uber rare 8350s with 2x threads and benches faster then it's replacement cpu......

i use petg. I don't have a chamber for abs setup yet. lost motivation to finish that.

Nailed it!!!^^^^

Have they listed all the colors? i know they are going to do a lot.i hope they are going to do a blue light blue or white light blue. i am literally thinking about not getting my other comp running until the vue is available.

I know right? i spent all that time making fun of my ocd 1700 stomping my friends 8350 that i gave him for nothing. should have kept that 8350 for another two years.

wait..... the ryzen-5 1600x is slower then the fx8350. Seems legit. http://cpu.userbenchmark.com/Compare/AMD-Ryzen-5-1600X-vs-AMD-FX-8350/3920vs1489

ohhh i know i can just leave it off but i wanna make it look pretty. also i want to replace the stupid amp up audio cover. Its got rgb bling beneath it and i want to diffuse to light correctly into a bar. But just concerned to make sure i wont look over and see my pla melting to the board. I made a fan holder for my nvme on my asus board and remember seeing asus warn about temperatures around 62c. Even though i think i remember never seeing my nvme on the gigabyte board above get hotter then 54 with the 1070 blowing hot air on it.