KyoSohma

It stays running. After I kept turning it in and off it'll eventually come back. (Have to do that for about 30 minutes though) and then it's fine until I have to restart it and this issue comes back.

I can't get into the bios because it doesn't even get to that screen.

I don't think it's a bad drive, because my os is on an ssd that's only a year and a half old. I also tried unplugging all drives except my ssd, but it didn't change anything

So, my computer has been working fine for months however recently it's started to not post. The computer powers on, leds light up, fans spin, but no image on the monitor. If I keep turning off the power supply and turning it back on, it eventually posts and boots to windows. Then if I reset my computer, the issue comes back. I7-7700k Asus strix 1080ti Asus tuf mark 1 z270 Evga supernova 650 g2 Kraken x62 Windows 10 64 8x2 ddr4 3200 trident z I've tried booting with one ram stick, CPU and drive, but it didn't change anything. I would appreciate any help, thank you.

Are the four cat 5e cables in the box in the garage the ends of the ones run throughout the house? And if so, I have ~10 phone panels, where are the rest of the cables ending at?

@dalekphalmNot that i'm aware of. The only box on the inside that has cat cables (the only box period, besides the breaker) is the one from the garage

That's the inside of the phone line panels, a cat 5e cable.

@Levent What RJ12 cables?

And I am renting it. The phone company box, is that the left most one?

My current ISP is charter spectrum

Hello! So, I live in on base housing on a military installation and my house has a phone line in basically every room. I got to thinking today (I watch a lot of networking content and such) what cable did it use. I unscrewed the panel and found cat 5e. I know that I can disconnect the wiring from the phone jack and rewire and crimp it into an Ethernet jack. I also know that I need the other end of the cable to be plugged into either a router, or a switch that is plugged into a router. What I don't know is 1) if I would be allowed to fiddle with the wiring in the house, 2) what I need to do and where, 3) if this would even work with the way the house is built. Any help would be appreciated. This is located in my garage on the wall against the neighbors garage. There are four cat 5e cables at the top. This is on the right side of my house. The bottom of the four boxes is mine and it only has coaxial cables in it, and a green wire. This is the left most box.The top line is my house.

Hey! I've been browsing looking for a monitor recently and I can't seem to find what I'm looking for. I want to find a 1440 144 monitor 1ms (preferably curved) that's all black. I found this one but I don't know if it's good for my money or if there's a better one out there. Thanks, kyo

Both fans are spinning, i don't hear any coil whine. I'll replace the thermal paste. The issue is that the only kind i have is the stock one included with the hyper 212, don't know if it's of a high enough quality.

I wasn't trying to be a dick, I was confused as to why you simply dropped the download link with no explanation. My window is wide open with an air vent underneath my desk with the a.c. on. I would approximate it to be 65-75 Fahrenheit

I already have ddu. It's for uninstalling drivers, why did you comment this?