Jump to content

june_yah

Member
  • Posts

    8
  • Joined

  • Last visited

Reputation Activity

  1. Like
    june_yah reacted to LukeNukem9 in No Video After Ram Swap   
    Make sure you have no: A. Bent CPU pins. B. Bent PCI-e connector. C. no bent mem. pins
    Also short the clear CMOs jumper to clear any failed OCs.
  2. Like
    june_yah reacted to limegorilla in No Video After Ram Swap   
    Normally I would go and tell you to reset your CMOS (if you had not done that allready) but that motherboard is the most temperamental thing I had in my last system. The one, surefire way of getting it back up (I had an issue similar to this back when I was using it) was to take to board out of the case, reset CMOS, leave unplugged for about half an hour, and then reassemble my system
  3. Like
    june_yah reacted to Mark77 in How long till I MUST upgrade i5 Haswell?   
    Considering that even the 6-year-old Sandy Bridge platform is still, with a modernized video card, good for most gaming, I doubt you'll have a problem with Haswell for at least the next few years.  Hopefully your financial situation improves a bit by then. 
  4. Agree
    june_yah reacted to SLAYR in Bandwith Compatiblity Question: Corsair Vengeance   
    It shouldn't matter, only if there is an "e" for unregistered ecc, "r" for registered ecc, or an "s" for sodimm would you possibly have issues. Never heard of "j", but it should be just standard ddr3 1600MHz, which may also have a "u" at the end depending on the maker.
×