libykim
-
Posts
54 -
Joined
-
Last visited
Reputation Activity
-
libykim reacted to Ajukrezi in Noctua NF-A14 (140mm) at 550 RPM normal?
Noctua NF-A14 PWM 140mm Blæser - 140 x 140 x 25 mm, 300~1500 RPM,
the operating range is between 300-1500 and is set via PWN. all low noise fans are running slower, but are still moving alot of air.
if you need more airfow yes you can raise it but at 35c your system is more than fine.
-
libykim reacted to Jurrunio in Noctua NF-A14 (140mm) at 550 RPM normal?
if the PWM% is the same, then yes
You could test, but ideally both should go faster.
-
libykim reacted to Daniel Z. in NZXT H510 top exhaust fan replacement?
Get the 140mm. It makes a lower pitched noise even at the same decibels as a 120mm so it sounds a lot less bad. Pushes more air too.
-
libykim reacted to Glenwing in How can I get chroma subsampling 4:4:4
GTX 750 Ti does not support HDMI 2.0, it is HDMI 1.4. The maximum is 4K 60 Hz 4:2:0, or 4K 30 Hz 4:4:4.
-
libykim reacted to EarthboundHero in Is it correct to install both Realtek and Nvidia audio drivers?
They both do different things. nVidia will be audio over HDMI from you GPU. Realtek will be for the audio ports on your mobo. So install both.
-
libykim got a reaction from STRMfrmXMN in How can I tell if this PSU's 800W is peak or continuous?
I was hoping someone "knew" rather than "assume" it is bad, but I guess the very reason nobody really knows about it is because it really is pretty unknown and subpar, haha.
Alright then, a new PSU it is. I'll link this to my friend. Thanks guys.
-
libykim reacted to mikat in Did I damage my CPU and the fan? Tell me it is fine! PLEASE!
the fan can't really damage your cpu, so "IT IS FINE!"
-
libykim reacted to Oshino Shinobu in Did I damage my CPU and the fan? Tell me it is fine! PLEASE!
Coolers put quite a lot of pressure on the CPU. Touching that lightly isn't going to damage anything. I wouldn't advise stopping a fan when it's running, though. It can damage the motor and bearings.
-
libykim reacted to Lurick in Did I damage my CPU and the fan? Tell me it is fine! PLEASE!
The bracket that holds the CPU puts a good bit of force on it so unless you pushed down the fan by hitting it with a hammer and chisel a few times then you're fine.
-
libykim reacted to Bananasplit_00 in Did I damage my CPU and the fan? Tell me it is fine! PLEASE!
ITS FINE
-
libykim reacted to Beeeyeee in Did I damage my CPU and the fan? Tell me it is fine! PLEASE!
the mounting pressure wouldn't cause any kind of noise. i bet its from the CPU cooler's fan touching the heatsink. check that.
-
libykim got a reaction from GirlFromYonder in Did I damage my CPU and the fan? Tell me it is fine! PLEASE!
This forum is amazing!
It takes all my worries away~ and I feel free as a bird~
Thank you all, thank you.
Can't believe how active this forum is.
-
libykim got a reaction from SirRoderick in Did I damage my CPU and the fan? Tell me it is fine! PLEASE!
This forum is amazing!
It takes all my worries away~ and I feel free as a bird~
Thank you all, thank you.
Can't believe how active this forum is.
-
libykim got a reaction from PCGuy_5960 in Did I damage my CPU and the fan? Tell me it is fine! PLEASE!
I misread this for "rocket retention thing", and I was like, wow, there's such a thing in the pc called a rocket retention thing? so cool~
then i reread it later and found out it's just a socket... haha