Something I have wanted to try, making a custom loop. Been through a bunch of cases to choose from and parts choices and I think I have come to a final set. Looking for any info I might have missed for the choices made, and any advice anyone would be willing to give about the choices made. Keeping in mind this is a hypothetical build, based on current gen, with an eye to make it for next gen (i7 8700k->i7 9700k or whatever....and 1080 ti -> 1180 ti(2080 ti)). So I understand that the requirements may change and become drastically different for that (though heat supposedly goes down more than up over time...with some exceptions (gtx 480!!!)
MB Asus ROG Maximus Formula X
CPU i7-8700k Coffee Lake
Case Corsair 500d (possible alternates, 500d rgb, 1000d, be quiet! dark base pro 900...with psu issues, uses passthrough c13 plug, psu has c19 plug)
CPU Block EK-Supremacy EVO or EK-Supremacy EVO - Acetal
Ram 32 GB Corsair Vengeance RGB Pro 3000 (x2) 15-17-17-35 (possibly 2 of these instead of the 4x8 sticks that i had,also a question on speed, diminishing returns especially per cost above this, just a filler atm)
SSD OS Samsung 970 Pro M.2 2280 1TB NVMe PCIe G3
HD Storage WD Green 6tb
SSD Storage Samsung 860 Evo Pro (sata)
PSU Corsair AX1600i (I KNOW this is over kill....even OVER OVER kill)
GPU EVGA GTX 1080 TI FTW3 Elite Gaming Black (assuming Hydro Copper isn't available...which for the time now it isn't on this gen)
Tubing Primoflex Advanced LRT 3/8 5/8 (switched to clear if colored fluid)
PumpRes Swiftech Maelstrom d5 res 200m Pump Combo (squarish look comes with mount which I believe will work with bottom of case)...280mm tall in total, + aqua pipe
fitting right angle bitspower compression 3/8 5/8 (into gpu, from cpu, to/from chipset)x4
fitting straight bitspower fitting 3/8 5/8 (alternatively, straight ek fitting, but no right angle to match)x8
valve bitspower bleed valve (and a barb fitting to store elsewhere for this as a drain/fill) just noticed picture doesn't include plug
aqua pipe bitspower aquapipe (to stop the splash and reduce chance of bubbles re-entering with top reservoir return), if I undersand this correctly, this goes into the top of the res, then a fitting can be attached (then tubing)...adds height to a tall pump/res, in a short case, will have to see about sizes
radiator1 black ice nemesis 360 gts black carbon (front)
radiator2 black ice nemesis 280 gts black carbon (top)
biocide n/a->in fluid
liquid EK-CryoFuel Acid Green Concentrate 100 mL (x2....should be enough with spare?)
Specific urls will be added later if required, was thinking of orienting the two rads with the ports front / top so that one can directly (more or less) feed the other, then vertical gpu mounted as first input (after res/pump) to cpu, to lower left chipset block, out upper mid block to radiator and to that bitspower pipe to block bubble uptake. If you have made it this far thank you and any thoughts would be appreciated, specfically, those rads are high restriction. Will that pump be enough? Will the radiators be enough with noctua NF-12 and nf-a14 flx fans (low rpm from around 600-1200). Lastly will that reservoir fit? Thank you again.