Sam Harradine

Okay cool. thanks for the help

How thick do you reckon i should get? wasnt sure if id want something high density or normal memory foam, opinions?

Over lockdown i spent a lot of time sitting in my chair which caused the cushion to squish down to the point where i can feel the bars (lined in red in the image) on my maxnomic chair. I have taken it apart recently to try and let the seat cushion go back to normal if at all possible and realised that i might be able to put something in between the bars and under side of the seat cushion. Does anyone have any suggestions on what would work well? The only other thing i have tried is sitting on a pillow when sitting on the chair but want something a bit more permanent.

Yeah i figured that. Wasn't sure if there was anything i can do or if anyone knew what was actually going on as the voltages for the pins are reading expected ranges. Unfortunately it's a work PC and was here before i started so i couldn't choose the components.

Yeah, kinda. Everything with the cx500 works except the 24pin atx cable.

@mariushm thanks for the reply. I mentioned in my post that I have tested with a multimeter to make sure voltages were correct and everything looked fine. I also hadn't plugged any drives in as i only needed to get into BIOS.

So i was rerouting cables in my work PC yesterday and when i plugged everything back in the pc would no longer post. No beep, nothing. Jumping the 24 pin and using another PSU works, as you can see a bit of the monitor in the picture. I have tested the CX500 cables with a multimeter and everything looks like it should be working fine. Values seems good. The -12v rail was at -11.8v but I dont know if this is a problem. I can't see any physical damage to the PSU unit or cables/pins. The 24pin socket/plug on the motherboard seems fine also as it boots with another PSU. Is there anything i can do to get the CX500 working again? I have just tested with a GPU plugged into the board and powered off the CX500. Pc posted and displayed bios as expected.

"Broken" the amount of times i've been told something is broken and needs to be fixed when it reality the power cable has come loose or the thing isnt even turned on.....

Thanks very much

Hi I want to put my Base stations on the ceiling but don't want to drill them in right now. What is that super strong velcro Linus uses? Or any other good methods please

I meant delete my comment. Not the thread

yes, i think so. you need both dirvers though ofcourse

Cool thanks. I guess I could just measure it lol

Cheers, thank you. The vrms are the tiny black chips right? And the square grey ones are,,,,,mosfets? Vram I know are the big black square ones. Apparently it doesn't get too hot though

The vrm's still get hot. i dont want them to.