Jumper118

just air. phanteks PH-TC14PE was only at 1.425v

 yeah

Water it's at 4.927ghz on 1.4v but it can do 4.9ghz dead at 1.36v but the ram speed and bclk are lower. 

Just now, DildorTheDecent said:

That's good. CF bridge has more pins i think that an SLi bridge?

 

Wider and uglier though 

yes. dont worry i have a black one as well. i just wanted to use this one in case the pins shorted in some way and it fried the bridge. i have loads of these orange ones, but only 6 black one  

1 minute ago, DildorTheDecent said:

shows those benches boy

i am working on them now  

11 hours ago, Wingfan said:

whats holding it back?

Sandy cpus just have a wall which they can't go past no matter what.  That's why it's impossible to bin them on air because no matter how good they are air on air they won't go higher than there wall.  It's also means there are a few out there that do 5.8-5.9ghz under cold water though :D. 

The other issue is they all have really low cold bug so most don't boot below - 40c. The best do - 100c but normally the cold does really help.  As long as the load temp is below 20c you can be 100% sure the chip is maxed out. 

20 minutes ago, Wingfan said:

hey, is there an Air cooler that would outperform my H105?

Not that I know of.

31 minutes ago, Wingfan said:

5.4 on air on a Sandy Bridge, impressive! My Ivy screamed mercy at 5.0 with an AIO

Yeah its a shame the cpu won't go faster no matter what cooling I use as the voltage scaling is great.  I have 2 chips like this,  under 5.5ghz but very low volts.  My best one does 5.6ghz and that only needs 1.58v on cold water to keep it at 50c. 

1 minute ago, Wingfan said:

Nice!

 

thanks. for some reason that version of ab can only go to 1100/1575 where on my other drive they can do 1122/1645. i need to redo this at some point. also the i5 was running on air  not even over 80c in 3d benches. 

2 hours ago, Dawson Wehage said:

Love that XFX Led.

yes it does look nice  2 in a dark case look badass 

agreed

7 hours ago, Wingfan said:

6GHz ? geez, that Zambezi must have been very toasty even with exotic cooling

ya. 6ghz on phase.  

1 minute ago, Wingfan said:

i hope you have an efficient PSU lol

i might have a psu just for the fans.  

1 minute ago, Wingfan said:

LOL! to bad your on the other side of the Pond lol is that a motorcycle rad?

its an aqua computer airplex evo 1800. it takes 15 120MM fans 

13 minutes ago, DildorTheDecent said:

and what config is that loop in?

triple loop 1080 for gpu loop, 360x2 for cpu loop and  1x360 for nb and vrm block, but they all share the same res. 

yeah  sandy cpus tend to cold bug with my phase cooler, but they overheat at ambient temps inside so i went outside when it was -1c  my water temps were 1-2c and at the end top top of my res was turning to ice

2 hours ago, DildorTheDecent said:

 

that yung classified tho

2 classifieds cos we dont do single cards here  

Nope sent one back yesterday sending other back Monday or Tuesday. 

8 hours ago, Wingfan said:

3 Mars???

yes 2 new one used. both new ones didnt work  

3 minutes ago, tmcclelland455 said:

does that mean the Titan Xpoodle is a One:1

No cos a 1:1 isn't poo qnd a titan xpenis is.  A 1:1 is more like a 1080ti kingpin. 

9 hours ago, tmcclelland455 said:

this isnt a GT610

its the car equivalent 

2 hours ago, Wingfan said:

The Lightnings on the top is a nice touch also.

Do you have a shelf for all your CPU's?

 

lol my cpu wouldnt fit on a shelf. they live in cpu trays.   

35 minutes ago, Wingfan said:

You need another shelf lol

 

A few lights shining on them, the ultimate GPU shrine

Yes I'm going to get leds behind the cards on the top shelf

9 minutes ago, Wingfan said:

Dam!!! very nice collection!

 

thats some of them  

2 minutes ago, stconquest said:

You guys (OC'ers) are awesome 

thanks  

2x e5 2670 with 2 gtx 780 and a MORA 360 LT rad with 9 120mm fans.