Will these Ikea parts fit together for a desk?

[Abzzz]

So I'm looking to build a new desk using these parts;

http://www.ikea.com/us/en/catalog/products/40206462/ (for a desk leg)

http://www.ikea.com/us/en/catalog/products/90206474/ (second desk leg)

http://www.ikea.com/us/en/catalog/products/30264301/ (x4)

http://www.ikea.com/us/en/catalog/products/20210907/ (x1 cut a bit short)

http://www.ikea.com/us/en/catalog/products/40051196/ (x2 for the above cut item)

http://www.ikea.com/us/en/catalog/products/10251352/ (x2)

What I'm worried about is I want to have the desk legs turned sideways so I can set them under the desk tops, and I'm worried that since the width is larger than the desk tops for the desk legs that may cause some issues. Opinions?

[Bananasplit_00]

LOL this is the best post on LTTF right now also it actiualy might

[Abzzz]

>.> "might". Also wat lol

[Abzzz]

So, no thoughts on this? Hello? /echo echo echo echo

[ShadowMethod77]

Should work fine if you are pretty handy. Just be ready to measure twice, cut once, and deal with the results. I think it will look badass and I might actually make one for myself!

[Abzzz]

Thanks lol it's a mix of stuff I've seen on the internet + stuff I need like shelves for my consoles. Just curious about the desk legs since it's going to stick out a little.

[Eckho]

I don't see why it wouldn't work. As for the desk legs (shelves) sticking out a bit, you could put the table top flush to the front end of those and then get 4 of the slanted brackets and put two on the overhang of each shelf on the back and mount the top shelf (I'm assuming a monitor lift?) to those... if that makes sense?