Jump to content

Need help with creating GIF's

I'm new to the forum, please forgive me if thread is in the wrong folder.

 

Anyway, recently i've had a science project at school where I have destilled diluted acids. The project itself was quite succesfull, and now I am going to make a presentation to show off my work to my class.

 

The acids i used:

-Hydrochloric acid (HCI) Boiling point: 108 °C

-Nitric acid (HNO3) Boiling point: 83 °C

 

The reason i picked those two acids is because one is above water boiling point and one is below. 

 

This is the setup that i used, where the acid is to the right, and the burner underneath it. 

Z38Khh9.jpg

 

The first picture i need help with:

HlONYMP.png

NB, please don't use the paint pic i made, was just some quick things i made in class to just show the setup i was going to use.  I will be really happy if you make something that looks a little better.

 
Here, the burner will heat up the HCI and H2O. Since H2O has a lower boiling point and will therefore turn into gas. Since heat goes upwards it will go into the pipe and will then be cooled down by the watercooling. When it gets cooled down, it will turn back into water and then go down into the 2nd container on the left. 

 

What I need you to do, is to add some balls that are moving in the pipe. When the ball is exiting the first container, it will be red. When it is in the middle of the pipe, it will be cooled down, and the ball is going to turn blue. In the middle of the ball it should say "H2O"

Also add some flames from the burner underneath the container to the right. 

 

The second pic i need help with:

mktltY1.png

NB, please don't use the paint pic i made, was just some quick things i made in class to just show the setup i was going to use.  I will be really happy if you make something that looks a little better.

 
Here, the burner will heat up the HNOand H2O. In theory, the acid should have a lower boiling point than the water, and then be the first one to turn into gas. The gap between the two liquids is not very big, and there is a big chance that it will fail. (Spoiler: It did, more about that later)

 

What i need you to do, is just like the previous one, add some balls. In this case, HNOand H2O will be in the right container, and then when it gets warm, the acid will turn into gas and enter the container to the left. Just like the previous one, the balls should be colored red when they exit the right container, and then turn blue when they go further into the pipe. Inside the ball it should say  HNO3. Also maybe add some flames from the burner underneath the container to the right. 

 

The third pic i need help with: (same as the previous one)

mktltY1.png

NB, NB. Noticed a typo in the left container, it should say H2O.

 

NB, please don't use the paint pic i made, was just some quick things i made in class to just show the setup i was going to use. I will be really happy if you make something that looks a little better.

 

Now, this is where i'm going to talk abut the spoiler i mentioned a bit up. 

In theory, the 2nd try with the HNOand H2O should have went how i mentioned it, but it didn't. Before the experiment, i measured the boiling point for the water in our lab, which was at 93 degrees C. The difference between the boiling points were then at about 10 degrees C. After the experiment the container to the left was filled with water and the one to the right was filled with acid. My theory is that the acid was polluted which affected the boiling temp and made it go up. Then, the water's boiling point was under the acid's and made the water turn into gas and enter the left container. 

 

What i need you to do, is the almost the same as the in the 2nd pic, but instead of the HNO3 leaving the right container, the H2O is going to. Same as last time, make the balls, make them change color, and add flames. Inside the ball it should say H2O

 

 

In advance, thank you. <3

-RolfOskarBgberg // Saul Dogeman (Steam)

 

 

 

 

Link to comment
Share on other sites

Link to post
Share on other sites

What the.....

I thought you were asking on how to make .gif .... 

Security Analyst & Tech Enthusiast

Ask me anything.

Link to comment
Share on other sites

Link to post
Share on other sites

What the.....

I thought you were asking on how to make .gif .... 

Hahaha this^ me too

Link to comment
Share on other sites

Link to post
Share on other sites

What the.....

I thought you were asking on how to make .gif ....

^ this

Quote my post if you need me to respond.

Link to comment
Share on other sites

Link to post
Share on other sites

so what is the gif related question?

 

the thing you are asking sounds more like a animation kind of project, gif wouldn't be a good file for this because it loses quality FAST when the clip gets longer.

 

i suggest trying this yourself first, i get the feeling this is more like us making your homework if we do this, which, well... you know...

May the light have your back and your ISO low.

Link to comment
Share on other sites

Link to post
Share on other sites

tumblr_inline_nk87dxvzrg1rrpit5.gif

Windows 10 Edu | Asus ROG Strix X570-F Gaming | Ryzen 9 3950x | 4x 16GB G.Skill Trident Z RGB| ROG Strix GeForce® RTX 2080 SUPER™ Advanced edition | Samsung 980 PRO 500GB + Samsung 970 Evo Plus 2TB + 8TB Seagate Barracuda | EVGA Supernova 650 G2 | Alienware AW3418DW + LG 34uc87c + Dell u3419w | Asus Zephyrus G14

Link to comment
Share on other sites

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×