Jump to content

Sleeving Problem

Guest
By Guest
in Cases and Mods
 Share
Posted

Im on the last few wires of my 24 pin and after pulling out a wire noticed that there was about a millimeter (maybe a little less) of space between the crimp and the insulator covering. Would this exposed wire pose a problem? Should I cover it with a little electrical tape or just sleeve over it? I'm doing heat shrinkless paracord. Thanks! :)

Link to comment
Share on other sites
Link to post
Share on other sites
Posted

Im on the last few wires of my 24 pin and after pulling out a wire noticed that there was about a millimeter (maybe a little less) of space between the crimp and the insulator covering. Would this exposed wire pose a problem? Should I cover it with a little electrical tape or just sleeve over it? I'm doing heat shrinkless paracord. Thanks! :)

Just make sure it doesn't make contact with something else. Personally I would just put electrical tape over it and you're good to go.

LinusGGtips

Build It. Mod It. Customize It.

Link to comment
Share on other sites
Link to post
Share on other sites
Posted

Just make sure it doesn't make contact with something else. Personally I would just put electrical tape over it and you're good to go.

I already did and my individually sleeved PSU is done. Thanks :)

Link to comment
Share on other sites
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing Cases and Mods

×